Includes closure and end caps unless otherwise requested.
P3380 end cap used when distance to first anchor is up to 2″ (51 mm).
P3703 end cap is used when end distance to first anchor is over 2″ (51 mm).
Nail or anchor inserts to forms every 16″ (406.4 mm) to 24″ (609.6 mm).
Anchors are 8″ (203.2 mm) on center.
Material: Cold formed from 12 Ga. (3 mm) steel conforming to ASTM A1011 SS GR. 33 or A653 GR 33. A. Stainless steel available on special order.
Finish: Choice of hot-dipped galvanized (HG) conforming to ASTM A123 or A153, or pre-galvanized (PG) conforming to ASTM A653-G90.
Cold-formed inserts are manufactured from standard 12 gauge (2.7 mm) Unistrut channel sections conforming to ASTM A1011 SS GR 33 or ASTM A653 GR 33, unless otherwise noted.
To inhibit concrete seepage, all inserts (except spot inserts) are provided with closure strips and end caps or foam filler, unless otherwise requested.
Most concrete inserts are available in stainless steel on special order. Consult factory for ordering information.
A wide range of heavy-duty to light-duty “continuous” and “spot” concrete inserts are available for use in pre-cast, pre-stressed or poured-in-place concrete floors, walls or ceilings.
Cold-formed, standard-duty, light-duty and spot concrete inserts are available in:
Hot dipped galvanized (HG), conforming to ASTM A123 or A153;
Pre-galvanized (PG), conforming to ASTM A653 GR 33
Design loads, where shown, are based on 3,000 PSI concrete, unless noted.
Insert lengths range from 3 inches (76.2 mm) to 20 feet (6.10m) with a tolerance of ±1⁄4-inch (6.4mm).
Imperial dimensions are illustrated in inches. Metric dimensions are shown in parentheses or as noted. Unless noted, all metric dimensions are in millimeters and rounded to one decimal place.
Custom-designed inserts are available on special order. Consult factory for ordering information.